- CMOS Buffered Bypass
- 9VDC center pin negative
supply 150mA at least
-True stereo IN/OUT
- All IN/OUT are TS unbal-
anced 6.4mm jacks
- dimensions: 14x10x5 cm
- weight: 0,525 kg
There are 3 different algorithms offered into RAINDROPS.
1. A modulated delay
2. Pitch shifted delay
3. Large reverb
In order to change between Algorithms, hold down the SHIFT footswitch and press TAP.
On each algorithm you can save a single preset, by holding down both footswitches for 3 seconds.
This preset will be stored and each time you power off the effect, or you cycle through the algorithms, you will have these
settings as default.
A Modulated Delay is simply the effect where the Delay Ttime is modulated by an LFO.
On this algorithm the MODE CONTROL knob has the following functions:
MODE = 1 —> CONTROL = LFO RATE
MODE = 2 —> CONTROL = LFO AMOUNT
This algorithm has a Pitch Shifter as its Post Effect. The Pitch Shifter will control only the Wet signal.
The Post Feedback can have a drastic effect here, as each repeat will be shifted again.
On this algorithm the MODE CONTROL knob has the following functions:
MODE = 1 —> CONTROL = PITCH (from 0 to 12 semitones - none quantised)
MODE = 2 —> CONTROL = PITCH SHIFT AMOUNT
Additionally to the Delay signal, a long tailed reverb is added .
On this algorithm the MODE CONTROL knob has the following functions:
MODE = 1 —> CONTROL = REVERB DECAY
MODE = 2 —> CONTROL = REVERB MIX
Circuit: Analog signal, hybrid delay, Digital reverb
Bypass: Buffered opamp
