DrBrowns Deluxe Bottle Sterilizer, Инструкция пользователя

Страница: 6 / 36

6
5. Place the tray (part F) in the sterilizer heating chamber. Arrange the
bottles and other parts in the tray.
NOTE: If using Dr. Brown’s bottles and parts, see Figure A through
Figure G on the next page for suggested layout options. Both
narrow and wide-neck bottles are shown.
6. Close the main cover (part B) and arrange the parts on the grate as
shown in Figure C and Figure G.
7. Close top cover (part A).
8. Plug the power cord into an electrical outlet and press
the On Button (C). NOTE: When the sterilizer is turned
on, you will notice that cycle indicator lights (E) will
illuminate with a cycle of RED-BLUE-GREEN colors.
After this initial cycle-through of colors, the green
symbol will remain lit indicating “READY” mode.
Ready Cycle: With the green “ready” symbol illuminated, press
the cycle start button (D).
Heat Cycle: The red symbol will indicate that the appliance
is “HEATING” to create steam. It will remain lit until all water
is consumed and the sterilization cycle is complete. This is
approximately 8 minutes but may vary by the amount of water you
add, the number of items to be sterilized and other environmental
factors.
Cool Down Cycle: Upon the completion of the sterilization cycle,
the blue symbol will illuminate to indicate the “COOL DOWN”
cycle. Note: If you forget to add water to the unit and start the
heating cycle (red light on), the unit must complete the cool
down cycle (blue light on) before a new “heat” cycle can be
attempted. CAUTION: DO NOT OPEN STERILIZER DURING COOL
DOWN CYCLE.
READY (unload) Cycle: When the cool down cycle is complete, the
green “READY” symbol will again light. You may unload your items
or allow them to air dry.
9. Open the main cover and remove all bottles and place on a countertop
or other flat surface. Open the top cover and re-assemble the bottles
with the various components.
6