background image

COPYRIGHT

This manual is copyrighted © 2011 by Drawmer Electronics, Ltd. With all rights
reserved. Under copyright laws, this manual may not be duplicated in whole or in
part without the written consent of Drawmer.

ONE YEAR LIMITED WARRANTY

Drawmer  Electronics  Ltd.,  warrants  the  Drawmer  MX30  audio  processor  to
conform substantially to the specifications of this manual for a period of one year
from the original date of purchase when used in accordance with the specifications
detailed  in  this  manual.  In  the  case  of  a  valid  warranty  claim,  your  sole  and
exclusive remedy and Drawmer’s entire liability under any theory of liability will be
to, at Drawmer’s discretion, repair or replace the product without charge, or, if not
possible, to refund the purchase price to you. This warranty is not transferable. It
applies only to the original purchaser of the product. 

For  warranty  service  please  call  your  local  Drawmer  dealer.  Alternatively  call
Drawmer Electronics Ltd. at +44 (0)1709 527574. Then ship the defective product,
with transportation and insurance charges pre-paid, to Drawmer Electronics Ltd.,
Coleman Street, Parkgate, Rotherham, S62 6EL UK. Write the RA number in large
letters in a prominent position on the shipping box. Enclose your name, address,
telephone number, copy of the original sales invoice and a detailed description of
the  problem.  Drawmer  will  not  accept  responsibility  for  loss  or  damage  during
transit.

This warranty is void if the product has been damaged by misuse, modification or
unauthorised repair.

THIS  WARRANTY  IS  IN  LIEU  OF  ALL  WARRANTIES,  WHETHER  ORAL  OR
WRITTEN, EXPRESSED, IMPLIED OR STATUTORY. DRAWMER MAKES NO
OTHER WARRANTY EITHER EXPRESS OR IMPLIED, INCLUDING, WITHOUT
LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
FOR  A  PARTICULAR  PURPOSE,  OR  NON-INFRINGEMENT.  PURCHASER’S
SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY SHALL BE REPAIR
OR REPLACEMENT AS SPECIFIED HEREIN.

IN  NO  EVENT  WILL  DRAWMER  ELECTRONICS  LTD.  BE  LIABLE  FOR  ANY
DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING  FROM  ANY  DEFECT  IN  THE  PRODUCT,  INCLUDING  LOST
PROFITS, DAMAGE TO PROPERTY, AND, TO THE EXTENT PERMITTED BY
LAW,  DAMAGE  FOR  PERSONAL  INJURY,  EVEN  IF  DRAWMER  HAS  BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Some states and specific countries do not allow the exclusion of implied warranties
or limitations on how long an implied warranty may last, so the above limitations
may not apply to you. This warranty gives you specific legal rights. You may have
additional rights that vary from state to state, and country to country.
In the interests of product development, Drawmer reserve the right to modify or
improve specifications of this product at any time, without prior notice.

ii

Содержание MXPro MX30
















Отзывы: