Drawmer MC 3.1, Руководство пользователя

Страница: 7 / 28

7
MC3.1
- Monitor Controller
The MC3.1 unit will be supplied with an external switching mode power supply that
is capable of 100-240Vac continuous (90-264Vac max) and so should work globally.
We strongly advise that the power supply that has been supplied with the MC3.1 is
used, rather than one with the equivalent ratings. In addition, should the power
supply fail for any reason we strongly advise that you contact Drawmer for a
replacement rather than repairing the unit yourselves. Failure to do either of these
could permanently damage the MC3.1 and will also invalidate the warranty.
The power supply will be supplied with cable suitable for domestic power outlets in
your country. For your own safety, it is important that you use this cable to connect to
the mains supply earth. The cable must not be tampered with or modified.
Before connecting the MC3.1 to the power supply ensure that all knobs are
turned off (i.e. fully anticlockwise) and that the Level Switch just below the main
volume control is set to Knob. A switch next to the d.c. power inlet on the rear of
the unit switches the power on/off.
POWER CONNECTION
PORTABLE APPLIANCE TESTING
To undergo a Portable Appliance Testing procedure (commonly known as "PAT",
"PAT Inspection" or "PAT Testing") use any one of the screws that hold the feet to the
bottom of the unit. These screws connect directly to the chassis and provide the
earthing point. If required, the foot can be removed and the cavity probed, or the
screw can be replaced for something more suited to the job, such as a spade
terminal with a M3 thread.
SECURITY
To help protect the MC3.1 from theft the rear has a Kensington Security Slot (also
called a K-Slot) which enables the fitting of hardware locking accessories that can
attach your MC3.1 to an immovable object, making the MC3.1 more of a challenge
for the potential thieves to steal.