Silhouette/Series E & V by Draper
Page 4 of 5
6"
4¾"
Wiring Diagrams
Case Dimensions
Series E Viewing Surface Shown; Series V with Tab Tensioning also available.
At left, Series V slat bar is depicted inside case. Series E has a typical round
bottom dowel. For all Silhouettes, the dowel is concealed inside the case.
7
/
8
" holes for supply wires located on back
and top, 2
1
/
2
" from left end of case.
D
Silhouette D
Series E 6"
Series V Varies
Viewing Surface
www.draperinc.com
(765) 987-7999
Wiring Diagrams—110-120V Motor and Quiet Motor
with Built-in Low Voltage Controller
Please Note: Do not wire motors in parallel.
Single Station Control
Internal Screen Wiring
White (Common)
Black (Down)
Red (Up)
Green/Yellow (Ground)
Dashed wiring
by electrician
Control
switch
Single gang box by others
Min. 4" x 2
1
/
8
" x 1
7
/
8
" deep
Blue
Black
Red
Location of key
operated on-off
switch if furnished
To 110-120V Line
Multiple Station Control
Internal Screen Wiring
White (Common)
Black (Down)
Red (Up)
Green/Yellow (Ground)
Dashed wiring
by electrician
Red
Red
Black
Blue
Blue
Cap off with wire
nut and tape
Black
Red
Blue
Black
Single gang box by others
Min. 4" x 2
1
/
8
" x 1
7
/
8
" deep.
3 shown. More or less equally
feasible.
Location of key
operated on-off
switch if furnished
To 110-120V Line
Single Low Voltage Control
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Dashed wiring
by electrician
To 110-120V Line
Multiple Low Voltage Controls
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Dashed wiring
by electrician
To 110-120V Line
Wall Switch,
RF or IR
Receiver,
or integrated
control system
Wall Switches,
RF or IR
Receivers,
or integrated
control systems
Data Cable
Data
Cables
RJ-9
connector
RJ-9
connectors
Wiring Diagrams—110-120V Motor and Quiet Motor
the +5
V
UP 5V COM DWN
U
P
D
O
W
N
C
O
M
M
O
N
5V
Motor Data Cable
plugged in here
ILT Switch-to-Motor—
Dry Contacts or Data Cable connection
Please Note:
This
Splitter/Jack is
located inside the
junction box of your
screen.
Back of wall switch.
Please Note:
Although both Dry Contact and Data Cable connections are
shown, you should only use one connection type per motor.
Data Cables to
switches or to
additional motors
can be plugged
into any of the
three open jacks.
If this is a "Case
First, Screen
Later" installation,
plug the motor
cable into the jack
indicated in the
drawing.
Wiring Diagrams—Plug & Play 110-120V Motor
with Built-in Low Voltage Controller
Single Low
Voltage Control
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Multiple Low
Voltage Controls
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Wall Switch,
RF or IR
Receiver,
or integrated
control system
Wall Switches,
RF or IR
Receivers,
or integrated
control systems
Data Cable
Data
Cables
110-120V
Plug
110-120V
Plug
Please Note: 5V DC must be
connected to be able to set
limits using the wall switch.
