Channel
Selector
UP
STOP
DOWN
LED Lights
SHADE
SHADE
SHADE
BACK
Programming
Button
Pen
BACK
Programming
Button
Pen
BACK
Programming
Button
Pen
BACK
Programming
Button
Pen
SHADE
SHADE
upper
or
lower
limit
Section 5 -
RF Remote Programming Instructions
Please Note:
The motor ships with no programming. Follow these instructions to program unit to the desired transmitter.
Setting an Intermediate Stop -
Shade MUST BE in USER mode.
1.
Move shade to desired mid-point location
and hold MY/STOP button until motor
jogs.
2.
To test, press the MY/STOP button when
motor is standing still. The shade will move
to that intermediate location.
3.
To delete an intermediate stop, go to the
intermediate stop and hold the MY/STOP
button until motor jogs.
Add a Channel -
Shade MUST BE in USER mode.
1.
Select channel currently operating motor,
then hold programming button until motor
jogs.
2.
Select new channel to add to motor, then
hold programming button until motor jogs.
3.
The motor should now work on both the
old and new channels.
Delete a Channel -
Shade MUST BE in USER mode.
1.
Select channel operating motor that you
want to keep, then hold programming
button until motor jogs.
2.
Select channel to remove, then hold
programming button until motor jogs.
Motor should now only work
on channel kept from Step 1.
1.
Select a transmitter channel to assign motor. Hold UP and DOWN buttons
until motor jogs, then release.
2.
Check motor direction. To reverse motor direction, hold MY/STOP button for
5 seconds until motor jogs. Check direction again.
3.
Move motor to upper limit position. Hold MY/STOP and DOWN buttons until
motor moves down, then release. Use UP and DOWN buttons to move shade
to correct
lower limit and press MY/STOP.
4.
While motor is at lower limit, hold UP and MY/STOP buttons until motor moves
up,
then release. The shade should move to upper limit and stop.
5.
Next, hold MY/STOP button until motor jogs.
6.
Put motor into USER MODE by briefly pressing small programming button on
the back of the transmitter. Motor will jog.
7.
If programming additional shades on the same channel, put this motor to sleep
until all motors on the same channel are programmed. To put to sleep, hold
button on motor head for one jog, release. Then hold UP/STOP/DOWN all at
the same time and wait for shade to jog. Motor is now asleep.
8.
To wake motor up after putting to sleep, hold button on motor head for 1
second. Shade will jog to indicate it is now awake.
Adjust Limits in User Mode
1.
Move motor to limit
(upper or lower)
to be
changed. Shade must move to previously
set limit and will stop automatically.
2.
Hold UP and DOWN buttons until motor
jogs.
3.
Move motor to its new limit location and
hold MY/STOP button until motor jogs.
Reset Motor
1.
Hold button on remote and wait for
3 jogs. Motor is now reset.
page 6 of 8
Motorized FlexStyle
TM
