B
A
Section 4 -
Electrical Connections
Shade operates on 110-120V, 60 Hz. current. Shade is shipped with internal wiring complete and control switch
(es)
fully boxed, and standardly
supplied with a 6’
(1.82m)
cable lead. Wire to connect shade to switch
(es)
, and switch
(es)
to power supply, should be furnished by installer.
Connections should be made in accordance with attached wiring diagram, and wiring should comply with national and local electrical codes.
Caution:
DO NOT wire motors in parallel without written permission from Draper.
Caution:
All operating switches should be “off” before power is connected.
Please Note:
For low-voltage wiring requirements, Draper recommends consulting with a professional low-voltage electrical
contractor. It is very important that shielded and stranded CAT 5 cable be used to prevent any electrical interference.
1.
Grasp the flat end of the bracket.
(Motor Bracket shown.)
2.
Slip the small
curved end of
the tool under
the curved end
of the bracket.
3.
Pull off Bracket
Cover.
(A)
4.
Pull off Bracket
Cap.
(B)
Section 3 -
Removing Bracket Covers
(Must be ordered separately.)
Please Note:
The Cover Removal Tool
(Part Number C202.053)
is available if bracket covers need to be detached for any reason.
page 5 of 8
Motorized FlexStyle
TM
