1.
Mark wall, jamb or ceiling for placement of mounting endcaps.
2.
Drill small starter holes
(if necessary)
in mounting surface.
3.
On small endcap, drill out hole closest to wall and insert rubber grommet into
enlarged hole
(Fig. 13)
.
(A
3
/
16
" drill bit is included in hardware kit)
.
4.
For endcaps, snap end covers into place
(Section 3, Fig. 5)
.
5.
Mount endcaps using appropriate fasteners for surface
(Section 3)
.
6.
Attach cable deck or wall mount to mounting surface
(Fig. 14)
.
7.
Attach cable to deck or wall mount using provided washer and nut.
8.
After making sure of length required, cut cable and strip approximately ½" of protective jacket.
Section 6 -
Endcaps with Fascia—Side Cables
9.
On small endcap, run cable up through rubber grommet. On large endcap, cable will simply drop down
through back of chain guide.
10.
Place washer and cable stop sleeve on cable so that they are flush with inside of cable guide insert.
(It may
be necessary to strip more protective jacket from cable end)
.
11.
Crimp cable stop sleeve using a cable compression tool.
12.
Install cable guide insert as shown below
(Fig. 15)
.
13.
Mount shade. Place spring-loaded pin into bracket, depress pin by pushing shade roller toward bracket,
slip notches on operator end into other bracket, then press down to lock in place
(Section 1, Fig. 2)
.
14.
Remove cable from cable deck or wall mount. Thread cable down through dowel rod, then re-attach cable
to cable deck or wall mount.
Please Note:
Make sure cable is taut. Tension to 8 in-lbs, so shade will move up and down easily along cable.
Figure 16
STEP 2
Clicks into place
STEP 1
STEP 2
Clicks into place
STEP 1
Square Fascia
Radius Fascia
Large Hardware
Small Hardware
For Wall Mounting
For Ceiling
Mounting
For Wall Mounting
For Ceiling
Mounting
Figure 15
Figure 14
OR
Figure 13
page 7 of 8
Exterior FlexShade
®
- Clutch
Exterior window shade with smooth, quiet operation, and independent control
