Section 5 -
Hanging Screen
Section 5.1 - General:
1.
Wall Mounting Brackets
(minumum of 2)
must be attached to the case regardless of mounting method.
2.
Screen should be lifted into position only by case end caps. Keep case level by lifting case end caps
simultaneously to prevent surface damage. Never attempt to lift screen along its length.
3.
When locating viewing surface and checking clearance for screen’s operation, remember surface is
centered in case. Handle case carefully to protect its finish.
4.
Regardless of mounting method, screen should be positively and securely supported so that vibration
or even abusive pulling on viewing surface will not cause case to loosen or fall. Installer must ensure that
fasteners used are of adequate strength and suitable for mounting surface chosen.
REFER TO DIAGRAM ON LAST PAGE OF MANUAL FOR WALL BRACKET DIMENSIONS
Section 5.2 - Wall Installation:
1.
Secure the Mounting Brackets (minumum of 2) to the wall using appropriate hardware
(by others)
.
CAUTION:
Product is very heavy: Installer must provide adequate attachment hardware and
anchors as required. Installer must also ensure that structure is of adequate strength.
2.
Ensure that
mounting brackets
are level.
3.
Slide all
Bracket Locks
to the center of case.
4.
Holding the case by the endcaps, lift it up and over the cleats on the
mounting brackets
(see Fig. 5)
.
Wall Bracket Mounting Channels are shown in Fig. 6 below.
5.
Once the case is settled on the mounting brackets, slide the
Bracket Locks
to the center of each
mounting bracket
(see Fig. 6)
and secure set screw on the lock.
Ceiling Mounted
Appropriate
hardware
provided by
installer.
Wall Mounted
Appropriate hardware
provided by installer.
Figure 5-A
SIDE VIEW
Wall
Mounting
Bracket
SIDE VIEW
ACUMEN
Figure 5-B
Mounting Har
dware
(by others)
NOTE: It is the r
esponsibility of the installer
to select mounting har
dware appr
opriate
for the mounting surface
WALL
STUDS
16” (406mm) on center shown
MOUNTING BRACKET
Figure 4
Figure 3
Figure 4
Slide to lock case to
Bracket
Slide to lock case to
Bracket
Wall Bracket Channels
for Case Mounting
12"
(305mm)
Max. Distance
Optional
Center Bracket
One Wall Bracket
Centered
Figure 6
page 4 of 12
Acumen
™
E & V - 220V
