Draper 36327, Инструкция по эксплуатации

Страница: 13 / 20

13
9. OPERATING THE WATER BUTT PUMP
9.3 INSTALLATION - FIG. 5
The pump must be fully submersed before the power
is switched on. Do not turn the pump on when its dry.
Models 36376 & 38241
These models include a Li-ion (Lithium Ion) battery.
This battery must be fully charged before use.
- Model 36376 achieves this by means of a mains
charger. Charging of the battery should always be
done indoors away from rain or other water.
- Model 38241 achieves charging of the battery by
means of the mains charger as detailed for the
model above. Model 38241 also benefits from a
solar panel, the solar panel when connected to the
battery will provide a trickle charge to the battery,
this is designed to be able to keep the battery
charge topped up (actual charge applied to battery
depends on available sunlight and suitable
positioning of the solar panel). On occasions of low
sun or sunlight not directly striking the solar panel
the use of the mains charger may be required to
complete the charging of the battery.
9.4 POSITIONING THE PUMP - FIGS. 6 - 7
When submersing or lifting the pump it is necessary
to use a rope or chain, this must only be attached to
the transport handle. If pumping water from a sandy
or muddy water butt, the pump can be suspended
using a rope or chain (not supplied) fixed to the
handle. Do not use any of the electric cables
for this purpose, alternatively, stand the pump on a
brick to raise it up from the dirt.
*Actual handle position on pump may differ from
illustration.
FIG.5 *
FIG.6 *
FIG.8
FIG.7 *
9.5 FLOW REGULATING - FIG. 8
When the pump is operating the flow of water can be
reduced. Turn flow control
to regulate accordingly.