Dramm Hydra SprayTrax, Руководство пользователя

Страница: 5 / 20

Your Spraytrax comes to you ready to spray. After removing the sprayer from the crate, check
the tank for any additional parts and accessories. Connect the spray gun to the hose using
the quick disconnect. Your machine is now ready for use.
The Dramm Hydra SprayTrax™ is a hydraulic sprayer that offers a variety of flow rates with
a variety of pressures to allow for maximum flexibility. The Hydra can apply all formulations
of chemicals including insecticides, fungicides, Insect growth regulators, plant growth
regulators, and disinfectants. The Hydra can output all formulations without damage or
corrosion to the pump.
The Dramm Hydra SprayTrax includes either a 1.5 HP electric motor or a 5.5 HP Honda
gasoline motor and a
close-coupled pump capable of 4gpm electric or 8 gpm gas and 550psi, 50 or 100 gallon
tank, maneuv erable SprayTrax™ cart with self-tracking axle design, a convex reel with a
separate lock and variable drag system, 250 feet of high pressure spray hose, and a
variable pattern trigger spray gun.
START UP
1. Either switch on the electric motor or Pull-
start the Honda motor by setting the motor
speed to fast & engaging the choke.
for
more on motor operation see the motor manual
pg 15.
2. Fill the sprayer to the desired level.
Do Not
operate the sprayer empty for more than a
few seconds. The water acts as a coolant
and lubricant for the pump and damage
may occur.
3. Start the sprayer with the pressure control
knob in the START position. (A).
Do Not
attempt to start the sprayer under pressure
as this will stall the motor and cause an
overload condition.
4. After starting the sprayer allow it to run with
the pressure control knob in the start
position. This will remove any air from the
system, which can harm the pump.
5. Engine speed should not exceed 3,500
RPM. Maximum speed should be set using
the adjusting screw located directly above
the throttle lever of engine.
A.
Hydra SprayTrax Manual 6
Introduction
Assembly & Preparation
NOTE
• Always start and shutdown your sprayer
with the pressure regulator in the START
(priming) position.
• Keep inlet filter clean.
• Always rinse the tank and flush the pump
with clean water after each use.