Installation and adjustment instructions
Terrace awning Family EVO
Document name: 2010 EN Instrukcja Family EVO 2,11 | date: 08.07.2010 | page: 6 / 11
●
measure the length of the visible part of bolt
C on the arm holder (if it is more than 3,7 cm use
instructions from point 3.5 and screw it in)
C
max 3,7 cm
●
check the front bar position by using the table
below
Slot E
Visable part of bolt C
1 (top)
3,7 – 3,39 cm
2
3,39 – 3,08 cm
3
3,08 – 2,77 cm
4
2,77 – 2,46 cm
5
2,46 – 2,14 cm
6
2,14 – 1,83 cm
7
1,83 – 1,52 cm
8
1,52 – 1,21 cm
9
1,21 cm – 0,9 cm
10,11
Are not used
E
F
G
●
adjust as to lead to compliance with the above table
●
Roll out the fabric until it lies on the arms of
the awning (to do this with an electric engine you must
change the marginal settings according to the
instructions of the engine)
the fabric lying freely
●
screw out both allen screws G in arms
●
shift the angle so the toothed bars F from every arm is supported on the same E slot.
●
check if the toothed bars F are properly fitted in the E slot.
●
screw all the allen screws G in all arms.
Durring screwing , press the elements as shown on
the figure.
Press the pointed
elements
While helding this position,
screw the allen key G.
●
strain the fabric and check if the front bar is mounted correctly (if yes, then in case of an awning with
an electric engine, it is reqired to again change the marginal settings of the awning according to the
instructions of the engine)
