Installation and adjustment instructions
Terrace awning Family EVO
Document name: 2010 EN Instrukcja Family EVO 2,11 | date: 08.07.2010 | page: 2 / 11
●
had montage training courses at Dragon company
●
instructs the user about proper/safe usage of the awning
Information
Awning montage, adjustment and trial runs may be only performed by a qualified
montage company/persolel. Montage company is responsible for proper installing and
adjusting the awning (by using proper anchors for montage surface) adjusting the
awning and testing it.
1.5.
Anchorage and hoisting on ropes
If awning is to be hoisted on ropes, it is required to:
●
unpack the awning
●
solidly anchorage awning on rope, in order to prevent realising
●
when hoisting awning on ropes it is required to keep it in a horizontal position at all times
2.0.
Necessary tools
●
ladder / scaffolding
●
spirit level tool
●
rope to hoist
●
measuring tape
●
hammer, drill and drill bits (depending on the montage surface)
●
allen key(allen 3mm, 6mm)
●
wrench (SW11 included to the product)
●
socket wrench (SW13)
●
tools suitable for the chosen montage method (anchor type etc)
3.0.
Order of assembly
3.1.
check the content of delivery
3.2.
mark and attach mounting brackets to the monting surface
3.3.
bringing power to the awning engine (in case of ordering an electric engine)
3.4.
hang awning on brackets and fasten it
3.5.
set the angle of the awning
3.6.
regulate the position of the front bar
3.7.
prepare electric connection (in case of ordering an electric engine)
3.8.
Usage of crank (for awnings with manual drive or NHK)
3.1.
Check the content of delivery
before mounting, it is required to check:
●
if the awning type, colour and patern of the fabric, colour of construction, drive type (crank / engine)
and drive side is in accordance with the order
●
if proper parts in proper quantity were delivered (look Content of delivery pos.1.2.)
3.2.
Mark and attach mounting brackets to the monting surface
The awning is supplied with brackets for installing to the wall or ceiling
– compatible with the order. Awning
meets the specified wind class only if it is installed in accordance with the manufacturers precommendations,
the right type of mounting brackets including appropriate anchors, at the appropriate monting surface.
Before installing, check whether the monting surface is suitable for mounting – in case of weaker strength of
the monting surface structure it is required to order additional mounting brackets (quantity delivered as
standard has been provided for the monting surface with B25 class concrete strength ).
●
Mark on the monting surface where the brackets should be placed and then drill holes. (location of
the bracets are shown on the figure bellow)
