Dräger CPS 5900 Training, Инструкция по эксплуатации

Страница: 9 / 24

Cleaning and disinfection
Dräger CPS 5900 Training 9
4 Cleaning and disinfection
1. Prepare a cleaning solution containing water and a
cleaning agent.
2. Clean all parts using a soft cloth and the cleaning solution.
3. Thoroughly rinse all parts under running water.
4. Prepare a disinfectant bath containing water and a
disinfectant.
5. Put the training suit into the disinfection bath.
6. Thoroughly rinse all parts under running water.
7. Remove any excess liquid from the training suit, e.g. with a
sponge, before drying.
8. Dry the training suit.
9. Allow the inside and outside of all parts to air-dry (tempera-
ture: max. 40 °C). Keep out of direct sunlight.
The training suit can be dried by blowing with dry, oil-free
compressed air or in a suit-drying cabinet:

Maximum temperature: 40 °C (104 °F)

Minimum drying time: 120 minutes
5 Storage

Close the fastener system up to approx. 5 cm from the end
stop.

Regularly check whether the fastener system is adequately
greased.

Store the training suit in a cool, dry, dark and airy place
without pressure or stress. Keep out of UV light and direct
sunlight; avoid ozone. Observe permitted storage tempera-
ture (see “Technical data” on Page 10).

Follow ISO 2230 and national regulations for storage,
maintenance and cleaning of rubber products.

Carefully fold up the depressurized training suit:

Do not crease suit material, visor, seams and fastener
system.

Lay sleeves across the chest part.

Roll up the trouser legs and place them on the sleeves.

Lay head of suit across rolled-up trouser legs.

Place the training suit inside carrier bag and store in the ap-
propriate storage compartment or lay flat in a textile-lined
bay. Avoid wear caused by constant friction against the
storage surface.
6 Disposal
6.1 Service life
The training suit can be used as long as it continues to fulfill its
practical purposes.
6.2 Notes on disposal
The training suit must be disposed of in accordance with the
applicable waste disposal regulations.
CAUTION
Do not use any solvents (e.g. acetone, alcohol) or
cleaning agents containing abrasive particles for
cleaning and disinfecting. Only apply the described
procedures and use the specified cleaning agents and
disinfectants. Other agents, dosages and contact
times may damage the product.
For information about suitable cleaning agents and
disinfectants and their specifications, refer to
document 9100081 at www.draeger.com/IFU.
CAUTION
The training suit may not be tumble-dried.
The training suit must be completely dried to prevent
the formation of mold.
!
!
CAUTION
The training suit may be damaged if you fail to ensure
proper storage conditions!
!