Dräger Alcotest 6820 med, Инструкция по эксплуатации

Страница: 28 / 40

28 Dräger Alcotest 6820 med
Use
While the breath sample is given,
a continuous tone sounds, the green
light is illuminated and,
Blow appears
on the display.
When the breath sample has been
given, the green light goes out, the
continuous tone will stop and a short
clicking sound can be heard.
On the display,
Analyzing appears.
The test result will appear on the display
after 5 to 25 seconds (depending on the
the device temperature and the
measured concentration).
The measurement result is displayed
with the corresponding unit. The units
are factory-set to mg/L (milligrams of
ethanol per litre of breath) and can be changed via the menu. In
addition to the result of the measurement, an acoustic signal is
output, e.g.:
 PASS (low range) – 1 x,

ALERT (middle range) – 2 x,
 FAIL (high range) – 3 x,
4. Push the mouthpiece
upwards out of the
mouthpiece receptacle.
5. Dispose of the mouthpiece in
accordance with local
regulations.
3.3.1 Carrying out another measurement

Press the key to prepare for a new
measurement.
While the device is waiting until it is
ready to take a measurement, see
section 11 on page 34, a seconds
counter and a rotating bar appear on the
display.
NOTICE
While the result is shown on the display, a measurement
record can be generated with the optional Dräger Mobile
Printer (Order No. 83 19 310). Completed tests can be re-
printed from the
Last Tests menu.
01333400_en
Blow
01433400 en
Analyzing
mg/L
0.00
01533400
i i
NOTICE
Switching off the device intermittently will not reduce the
waiting period until it is ready to take a measurement!
00933400
01633400
1 s
OK
i i