Battery position is important so please pay close attention to centering the battery under
the GPS antenna flap. Also be very careful to make sure the battery doesn’t make
contact with the electronics directly in front of the battery. Double check and make sure
you have a gap between battery and electronics.
To install, lift the GPS antenna
mounting flap and place the
battery on the helicopter deck
plate.
Ensure the battery is not
touching the GPS module
located in front of the battery
and double check to make
certain the Velcro is secure.
Once the battery is seated,
allow the GPS antenna flap to
rest on top and wrap around
the battery. Attach the flap to the Velcro mount along the side of the battery.
Before you’re ready to fly, connect the main power cable from the helicopter to the
battery. The connector is polarized so it will only connect in one orientation.
Page 13
Leave a gap between
battery and electronics
Special notice:
We know you’re excited to get out flying but only connect the main power
cable when you’re ready to get up in the air. Leaving it plugged in for any length
of time even when powered off, will slowly drain the battery.
Содержание Draganflyer X4-ES
