DR XD26, Руководство по безопасности и эксплуатации

Страница: 22 / 44

22
DR
®
FIELD and BRUSH MOWER
Removing and Replacing the Drive Belt
Tools and Supplies needed:

1/2
″
Wrench

Gloves
Note: Wear Gloves to protect your hands.
1.
Remove the Seven Bolts that secure the Rear Cover Plate using a 1/2
″
Wrench and Remove the Cover (Figure 38).
2. Remove the Two Bolts and Wing Nuts that secure the Multi-tool to the
Lower Handlebar (Figure 39).
3. Use the Multi Tool to pull the Tensioner Spring off the Shoulder Bolt (Figure
40).
Tip: If you insert the hook end of the Multi tool from the right side of the Spring
loop, you can grab the end of the Spring to pull it from the Shoulder Bolt.
4. Wrap a rope around one side of the Drive Belt and pull down and to the side
to remove the belt from the Drive Pulley.
5. Reach inside the Frame to lift the Belt off the Transmission Pulleys (Figure
41).
6. Remove the Belt.
7. Reverse steps for installing a new Belt.
Transmission
Pulleys
Figure 41
Idler Pulley
Bracket
Figure 40
Drive
Belt
Spring
Multi Tool
Multi Tool
Figure 39
Bolts and
Wing Nuts
Rear Cover
Plate
Figure 38
Bolt (7 Places)