DR XD26, Руководство по безопасности и эксплуатации

Страница: 16 / 44

16
DR
®
FIELD and BRUSH MOWER
Blade Engage
Lever
Figure 26
Engaging the Blade
1. With the Engine running, hold the Operator Presence Control Lever down to
the Grip with your left hand without touching the Drive Levers. (Figure 18).
2. Push the Blade Control Lever forward, then to the left and down to the
“Engaged” position (Figure 26).
Note: If you engage the Blade Control Lever before holding down the Operator
Presence Lever, the Engine will shut off.
Stopping the Blade
1. Stop the Blade by pushing the Blade Control Knob up and to the right, then
pulling back to the “Disengaged” position (Figure 26).
Note: Releasing the Operator Presence Lever will stop the Blade and also cause the
Engine to shut off. The Engine will not start again until the Blade Control Lever is
moved to the “Disengaged” position.
Cutting Brush and Saplings
DECK PIVOT BOLT ADJUSTMENT (aggressive mowing conditions)
For aggressive mowing (Brush and Saplings) the Deck Carriage Bolts should be adjusted all the way down to stabilize the Deck.
Note: The entire machine must be on a flat surface for the following procedures.
Tools Needed:

1/2
″
Wrench

5/16
″
Wrench
1. Hold the square portion of the Carriage Bolts using a 5/16" Wrench and
loosen both Locknuts from against the Frame using a 1/2" Wrench (Figure
27).
2. Turn the Carriage Bolts down until they are contacting the Deck Bracket.
3. Hold the square portion of the Carriage Bolts as you turn the Locknut
against the Frame to lock them into position.
Note: The Carriage Bolts should be adjusted all the way up for easy to moderate
mowing when aggressive mowing is finished.
Figure 27
Locknut
Frame
Carriage
Bolt
Deck Bracket
If you need to leave the operating position to clear debris from the deck, stop the engine, wait five minutes to allow all parts to
cool. Disconnect the spark plug wire(s), keeping it away from the spark plug(s).