16
DR
®
ROTO-HOG™ POWER TILLER - OPTIONAL ACCESSORIES
MAINTAINING THE DR CULTI-PACKER
Regular Maintenance Check List before each use
CHECK FOR LOOSE FASTENERS
1.
Before each use make a thorough visual check of the Culti-packer for any bolts and nuts which may have loosened. Retighten
any loose bolts and nuts.
CHECK FOR WORN OR DAMAGED PARTS
1.
Check for worn or damaged parts before each use.
2.
Repair or replace parts if necessary.
Replacing Parts
NOTE:
The Culti-Packer should be lowered to the ground (with no pressure on the Wheels) or taken off the Tiller completely for replacing
parts.
REPLACING BEARINGS
1.
Remove the Cotter Pins and Washers from the ends of the Shaft (
Figure 31
).
2.
Slide the Shaft out of the Frame.
NOTE:
The Spacers may slide off the end of the Tube as you perform the next
procedure. Make sure they are installed back on the tube correctly before
repositioning the Wheel Assembly into the Frame.
3.
Roll the Wheels with the Tube, Bearings and Spacers away from the Frame.
4.
Slide the Bearings from the Tube and install the new Bearings.
5.
Roll the Wheels with the Tube, Bearings and Spacers into position on the
Frame.
6.
Slide the Shaft into the Frame and through the Bearings in the Tube.
7.
Install the Washers on the ends of the Shaft and secure with the Cotter Pins.
REPLACING WHEELS
1.
Follow the “Replacing Bearings” section (steps 1 to 3) to disassemble the
Wheels and tube from the Frame.
2.
Replace damaged Wheel(s) with new Wheel(s).
3.
Follow the “Replacing Bearings” section (steps 5 to 7) to disassemble the
Wheels and tube from the Frame.
Cleaning
1.
Rinse the Culti-packer and dry off before storing.
2.
Clean out any build up of material from the Culti-packer Wheels.
3.
Clean any build up of material from your ROTO-HOG Tiller.
Storage
1.
Rinse the Culti-packer and dry off before storing.
2.
Store in a clean, dry area.
Frame
Cotter Pin
Washers
Figure 31
Washers
Cotter
Pin
Spacer
Shaft
Wheel
Bearing
Frame
