CONTACT US AT
www.DRpower.com
7
10.
First, with rubber centered on blade, use both lower holes in each slide hinge
as guide to drill 5/16" holes through first layer of aluminum and partially
into rubber (
Figure 5
). Then turn 3/8" thread cutting bolt into each hole and
tighten to secure each hinge.
11.
Second, at factory mark near each end of blade, drill 5/16" hole through first
layer of aluminum and partially into rubber. Turn 3/8" thread cutting bolt
into hole and tighten.
Note:
Park vehicle on level grade and install plow mount receiver (shipped
separately). Interceptor can be installed with leg turned up or down as needed for
proper push frame clearance (Shown turned up in illustrations).
12.
Insert interceptor into receiver (leg up) as shown in diagrams. Insert pin
through mount and hole in interceptor and lock tab (
Figure 6
).
13.
Hold push frame up in line with pair of holes on interceptor, that when
bolted, will hold push frame 6 to 8 inches above grade.
Note:
If lowest hole pattern is too high, then it is okay to turn Interceptor leg down.
14.
Insert bolts and lock nuts and tighten.
15.
Hang blade assembly into retainer grooves on push frame.
16.
Insert keyhole pin in hole, rotate pin just enough to allow it through second
hole and rotate it back to its secure position.
Figure 6
Push Frame
Tether Cord
Hitch Pin
Keyhole Pin
Interceptor
Lock Nut with
Flat Washer
Hair Pin
1/2" X 4" Bolt
with Flat Washer
Push Frame
Figure 7
Interceptor Leg Up
Bolts 1/2 X
4" with Flat
Washer
Mount Push Frame
6" To 8" Above Grade
Lock Nut with
Flat Washer
Plow Mount
Figure 5
Slide Hinge
1st
2nd
3/8 X 1" Thread
Cutting Bolt
2nd
Keyhole Pin
Push
Frame
Transport
Position
Figure 8
Содержание REDI-PLOW ATV
Страница 3: ...CONTACT US AT www DRpower com 3...
