6
DR
®
REDI-PLOW™ ATV
Chapter 2: Setting Up The DR
®
REDI-PLOW™ ATV
Assembly
Tools and Supplies needed:
Power Drill with 5/16" Drill Bit
9/16" Socket with Ratchet
Two 3/4" Box Wrenches
7/16" Wrench
Protective Eyewear
1.
Each end of the Rubber Cutting Edge has two factory marks (to match with
holes in Skid Bracket). Drill them out with 5/16" Bit (
Figure 1
).
2.
Mount Skid Bracket there. Tighten Bolts until head sinks flush with rubber
surface. Repeat at other end.
Tip:
When mounted-Skid Bracket should align flush with or slightly above
bottom of rubber.
Note
Rubber should be room temperature before assembly
3.
Apply soapy water solution to channel areas of the Rubber Blade and
Aluminum Blade where they will mate together (
Figure 2
)
4.
Align groove on rubber with groove in Blade, so Skid Brackets face back to
Blade.
5.
Slide rubber into channel in bottom of Blade and center it.
6.
Locate factory marks on back of blade. Place slide hinge on blade and align
both lower holes with marks on blade (
Figure 3
).
Tip:
When mounted-slide hinges should measure about 14-1/2" apart.
7.
Insert 2 square nuts in channel at end of blade and slide them over to line up
with holes at top of slide hinge (
Figure 4
).
8.
Insert bolts through holes in slide hinge and thread onto nuts inside blade.
9.
Make sure both lower holes in slide hinge are still in line with mark on blade,
then tighten 2 top bolts. Repeat at other end.
3/8" x 3/4" Bolt
Washer
2 Square Nuts
Flat Side Up
These Holes in Hinge line up
W/Factory Marks on Blade
(to set hinges 14 1/2" apart)
Figure 4
Slide Hinge
Factory Marks for Hole
Locations on Blade
Figure 3
1/4" x 1-1/2" Bolt
Factory
Marked
Hole
Locations
Lock Washer
Nut
Flat Washer
Skid
Bracket
Rubber Cutting
Edge
Figure 1
Aluminum Blade
Back Side
of Blade
Skid Brackets
Face Back Side of
Aluminum Blade
Figure 2
Содержание REDI-PLOW ATV
Страница 3: ...CONTACT US AT www DRpower com 3...
