DR PREMIER 44T, Руководство по безопасности и эксплуатации

Страница: 9 / 36

CONTACT US AT
www.DRpower.com
9
Assembling the DR TOW-BEHIND FIELD and BRUSH MOWER
Hardware Supplied in Product Package (Figure 3 and Table below):
Item # Part #
Description Qty
1 ............. 187371 ........ Pin, Clevis, 1/2" OD X 4.5" LG ................... 1
2 ............. 255491 ........ Pin, Clevis, 1/2" X 2-1/2", TRT ................... 3
3 ............. 157201 ........ Key, Ignition Switch .................................... 2*
4 ............. 234991 ........ Washer, SAE Flat, 1/2", ZP ......................... 4
5 ............. 160031 ........ Pin, Hair, 1/2" To 9/16", .12" Wire ............ 4
*One key may be attached to the machine
Compare the hardware of the Product Package with the “Parts Supplied” list
above. If you have any questions, please contact us at www.DRpower.com.
Attaching the Tow Bar to the Push Bar
The Tow Bar can be installed for offsetting to the right or left depending on
which side of the Tow Vehicle you choose to mow. See section “Offset
Mowing” in Chapter 3 to determine how the Tow Bar should be installed for
your needs. The following steps describe installing the Offset Bracket to allow
offsetting to the right side of the Tow Vehicle.
1. Secure the Offset Bracket to the Push Bar in the configuration shown (for
right side offset) using the 4.5" long Clevis Pin, Washer, and Hair Pin (Figure
4).
2. Align the Tow Bar so it is pointed straight out from the Mower and install a
Clevis Pin, Washer, and Hair Pin in the Offset Bracket to lock the Tow Bar in
position.
3. Align the Tow Bar Extension with the Tow Bar and install a Clevis Pin,
Washer, and Hair Pin in the Tow Bar to lock the Tow Bar Extension in place
(Figure 5).
Connecting the Remote Control (PRO and Pro XL Models Only)
Tools Needed:

Wire Cutters
Note: An optional UTV Extension Kit is available to give you more mounting
options for your machine by extending the Remote Control Wire Harness.
Visit our website at
www.DRpower.com
to order Kit # 365931.
1. Use Wire Cutters to cut the Cable Tie that is securing the Remote Control
Cable to the Frame for shipping.
2. Pull the Connector from the Blade Engage/Disengage Remote Control
(Figure 6).
Figure 6
Connector
Blade Engage/Disengage
Remote Control
5
Figure 3
4
3
2 1
Offset
Bracket
Figure 4
Push Bar
Clevis
Pin
Hair Pin
Washer
Clevis Pin
and Hair Pin
Washer
Tow Bar
Figure 5
Tow Bar
Extension
Washer
Clevis Pin
and Hair Pin
Tow Bar
Always install the Clevis Pins from the bottom with the Washers and Hair Pins
on top to prevent the Hair Pin from being pulled out by tall grass or bushes.