DR PREMIER 44T, Руководство по безопасности и эксплуатации

Страница: 23 / 36

CONTACT US AT
www.DRpower.com
23
Replacing the Carbon Canister (PRO and PRO-XL Models)
Tools needed:

Wire Cutters

Pliers
1. Remove the Gas tank Plate as described in section “Removing and Replacing
the Drive Belt” in this Chapter.
2. Cut the Cable Ties that are securing the Carbon canister and Purge Hose
(20hp Only) to the Gas Tank Plate using Wire Cutters (Figure 38a and 38b).
3. Remove the rubber Filter Elbow for better access to the Hoses.
4. Slide the Hose Clamps away from the Hose connections using Pliers and
twist the Hoses from the Canister.
5. Install the Hoses onto the new Carbon Canister and position the Hose
Clamps with Pliers.
Note: The Hoses MUST be installed onto the new Canister in the same location as
they were on the old Canister. The Canister is labeled “Purge” (this hose is
from the engine) and “Tank” (this hose is from the top of the fuel tank).
6. Slide new Cable Ties through the Canister Brackets and position the Canister
onto the Brackets. Make sure the Filter is facing down (the filter can be
rotated if needed).
7. Tighten the Cable Clamps around the Canister and cut the excess with Wire
Cutters.
8. Install a Cable Tie around the Canister Bracket and Purge hose to secure it to
the Carbon canister (Pro-XL 20hp Only). Do not over tighten the Cable Tie.
Figure 38a (Pro 16.5hp)
Carbon
Canister
Carbon Canister
Cable Ties
Filter
Purge
Hose
Tank
Hose
Hose
Clamp
Figure 38b (Pro-XL 20hp)
Carbon
Canister
Carbon
Canister
Cable
Ties
Filter
Purge Hose
Tank Hose
Hose Clamp
Purge
Hose
Cable
Tie