DR POWERWAGON-PRO, Руководство пользователя

Страница: 11 / 48

Contact us at www.DRpower.com 9
Unpacking the DR POWERWAGON-PRO
Tools & Supplies Needed:
•
Screwdriver
•
Hammer
•
Knife
•
Gloves
•
Eye protection
•
Metal shears
1. Stand to one side and cut the banding.
2. Remove the top of the carton. Cut the cardboard top to bottom on one of the narrow sides of the
box and peel it off the pallet. Be careful of the staples.
3. Pry off the fasteners and cut any ties holding the machine to the pallet.
4. Roll the DR POWERWAGON-PRO off the pallet. Do not discard your pallet and packaging material
until you are fully satisfied with your machine.
BE SURE TO FILL YOUR ENGINE WITH OIL AND GAS BEFORE USE. SEE PAGE 10.
Check the Tire Pressure
Tools Needed:
•
Tire Pressure Gauge
•
Air Compressor
1. Remove the Valve Stem Protective Cap and check the tire pressure with a tire pressure gauge.
2.
If the pressure is too low, add air through the Valve Stem with an air hose.
3.
Replace the Valve Stem Protective Cap when finished.
NOTE: The heavier the load, the higher the tire pressure should be. Do not go above the maximum recommended
load or pressure.
DO NOT OVER INFLATE THE TIRES. INFLATE TO THE MANUFACTURERS RECOMMENDED PRESSURE
FOUND ON THE TIRES.
ALWAYS WEAR EYE PROTECTION WHEN CUTTING THE BANDING. THE BANDING MAY HAVE A LOT OF
TENSION ON IT AND MAY SNAP, STRIKING YOU WHEN CUT. ALWAYS STAND TO ONE SIDE WHEN
CUTTING THE BAND.