www.sentera.eu
MIW-DRX-EN-000 - 27 / 11 / 2015
6 - 7
back to the table of contents
3.
Do the wiring according to the wiring diagram (see
Fig. 4
) using the legend
information from section
“Wiring and connections”
.
Fig. 4 Wiring
M
L L1 N N U
Speed adjustment
trimmer
Normal operation
LED indication
Output voltage
adjustment
potentiometer
Power
supply
Regulated output
M
L L1 N N U
Power
supply
Regulated output
Unregulated output
230 VAC / max. 2 A
4.
Switch on the power supply.
5.
Set the required output voltage with the help of the potentiometer on the front
cover. Adjust the minimum speed with the trimmer (if necessary). The factory
preset is 100 VAC. See
Fig 1
.
VERIFICATION OF THE INSTALLATION INSTRUCTIONS
When you switch on the power supply the LED for operating indication shown in
Fig. 4
should give out constant green light. If this is not the case, check the connections.
TRANSPORT AND STOCK KEEPING INFORMATION
Avoid shocks and extreme conditions; stock in original packing.
DR
ELECTRONIC FAN SPEED
CONTROLLER, DIN RAIL MOUNTING
