DR 10.5HP PRO-26, Руководство по безопасности и эксплуатации, Страница: 12 / 36

12
DR
®
FIELD and BRUSH MOWER
Handlebar Low
Position hole
Handlebar High
Position hole
Rear Handlebar
Bolt Removed
Figure 13
Handlebar Height Adjustment
We ship all DR Field and Brush Mowers with the handlebars in the highest
position setting. If you would like to lower the handlebars to the Low position
please follow these steps:
Tools Needed:

9/16” Wrench
1. Remove Rear Handlebar Bolt with a 9/16” Wrench from both handlebars
(Figure 13).
2. Loosen Front Handlebar Bolt on both handlebars but do not remove.
3. Align Handlebar Rear hole to Handlebar Low Position hole in the Frame.
4. Reinstall Rear Bolts on both handlebars.
5. Tighten Front and Rear Bolts on both handlebars.
Steering Brake Break-in
The Steering Brakes are standard equipment for the 16.5 HP and 20 HP Models. If your DR Field and Brush Mower is equipped
with Steering Brakes, the Brake Pads and Rotors need to be broken in (burnished) during the first use to ensure the best
performance. Please complete the following steps before using your machine and after you have read through Chapter 3:
1. Refer to Chapter 3 to start the machine and shift into second gear.
2. Engage the Traction Drive Lever to drive the machine forward.
3. Apply both brakes equally with moderate force and hold the brakes on for 100 feet.
4. Release the brakes for 25 feet.
5. Re-Apply both brakes equally with moderate force and hold the brakes on for another 100 feet.
Avoid contact with the Brake Calipers and Rotors during and after this procedure because the Brake rotors will become very hot
and may burn you.