DR. Z Amplification z-verb ZA-28, Руководство пользователя

Страница: 4 / 7

1 2 3 4 5 6 7
1. Input:
Input jack for your guitar or input from “send” jack when using your amp’s FX loop.
2. Tone:
Controls overall tone of reverb.
3. Mix:
Controls dry/wet mix. Turn clockwise to add reverb.
4. Output:
Output jack. You can send signal to the input jack of your amp or to the “return” jack when using
your amp’s FX loop.
5. Dwell:
Turn clockwise to add tail to reverb.
6. Power:
Switch up to turn on unit. Switch down to turn off unit.
7. Power Indicator:
Lights up when power is switched on. If bulb fails replace with type T47.
FRONT PANEL
REAR PANEL
9 10 8
8. Footswitch:
Plug supplied single bu�on footswitch in here*. The footwitch will enable you to turn
the reverb on and off. *
Use a shielded instrument cable(like you insert into your guitar) to connect the
footswtich to the unit.
9. Fuse:
The fuse protects the amp from electrical faults. Replace only with the same ra�ng and type
stated below fuse holder (.5A 250v SLO BLO). If the amp repeatedly blows the fuse contact your dealer
or Dr. Z Amps.
10. Ground Li�:
This switch li�s the ground connec�on from the chassis. Use this switch in the case of
ground loop hum or RF interference being amplifier through the unit.
11. AC Inlet:
(Class I Wiring). This device is used for disconnec�on from power mains and must remain
readily opearable. The power indicator light does not indicate connec�on to power mains. The power
cord must be disconnected to disconnect amplifier from power mains.
11