is in the highest sensitivity state.
b)Move the coil close to the ground and slowly within the area where
the target is found. At a certain position, the single frequency sound
rings, and the orchid color intensity LED lights up the first one. Continue
to slowly move the search coil until the sound is louder, and all four
intensity LED lights up with the lowest depth cursor. You roughly locked
the target just in the center of the coil.
c)If the area with the strongest signal is relatively large, and the
positioning is not accurate enough, you can keep the search coil
position unchanged, press the DISC / P-P key long, and exit the P-P state.
Press the DISC / P-P button again and repeat the above until the probe
moves slightly and the strongest signal becomes smaller, locking the
position of the metal target. You can mark the ground through the
center of the open tray to facilitate digging.
9. Detection tips
a)Exploration in the mineralized environment.
When the search coil scan the mineralized soil, the soil will produce an
interference signal and affect the detection. It is recommended that you
reduce the scan speed of the coil, which can significantly reduce the
impact of mineralized soil.
b)Detect on the beach.
When the detect on the wet beach, it will produce an iron-like signal. It
is recommended that you can also reduce the scanning speed of the
search coil.
c)In fact, PINPOINT is highly sensitive, and it is also an option to use it
directly for detection. In severely mineralized or salinized areas, you can
press the button to enter the PINPOINT mode where the search coil is
close to the ground, and then move the search coil slowly.
d)In places with large electromagnetic interference, you use PINPOINT
In addition, the operator needs to be reminded that both the
