4
GB
Assembling the massager
1. First unpack the
fl oor plate (J) with the
stand holder rod (F). Assemble the stand
holder so that it is in an upright position
(Fig. 1) and then fi x it with the screws that
are included.
2. Remove both of the retaining screws (G)
from the base (H) and pull out the stand
holder rod (F).
3. Use the retaining screws (E) to adjust to
the height you want.
4. Push the stand holder into the base until
all the screws are aligned.
Then put a snap ring, then a washer on
each of the screws (G), then put the 3
screws in the three holes for them before
tightening them (the third screw is in the
packaging is packed).
5. Insert the massager head with the end of
the rod into the stand. Tighten the retai-
ning screws (E) to fi x the massager at the
height you want.
6. Hang the massaging belt (C) in the
grooves in the belt holders (B).
7. Plug in the massager to the mains: your
massage equipment is now ready to use.
B
D
G
G
G
H
J
A
C
E
F
IMPORTANT!
The massager arrives in two separate pa-
ckages.
Package 1: massager head, massager belt,
massager accessories.
Package 2:
base plate with stand rod de-
pending.
