Figure 5
VIDEO RECEIVER (vRX) CONNECTIONS
Female RCA adapter cables are provided
for connecting your wireless Video
Receivers (vRx’s). The RCA cables are
installed on the rear panel’s RX1, RX2, and
RX3 phone jacks. See Figure 5.
Note:
If only two vRx’s are used then install
them at RX1 and RX2.
The RCA cable is color coded as follows:
Yellow: Video Out
Red: Audio-1 Out
White: Audio-2 Out
The female RCA connections can be converted to male plugs by installing common RCA patch
cables. If ImmersionRC brand receivers are used then an alternate connection m ethod is to
omit the RCA adapter cable and directly connect using ImmersionRC’s 3.5mm to 3.5mm
4POL
AV cable
, ImmersionRC item CABAV30 or CABVID3M3535 (sold separately). FatShark’s 4-Pin
AV cable (item FSV2008, sold separately) can also be used to direct connect ImmersionRC
receivers.
H
ELPFUL
T
IP
: The RX1-RX3 phone jacks are “direct connect” compatible with
ImmersionRC receivers that use their compatible 3.5mm 4POL AV cable. Other
receiver brands may NOT work with the direct connect method due to
incompatible wiring (signal order / pinout); The RCA cable should be used
instead.
It is also possible to build custom patch cables to work with your particular video receiver. The
RX1-RX3 phone jacks are 3.5mm TRRS type that have 4-conductors for Ground (shield), Video
(yellow), Audio-1 (red), and Audio-2 (white). The phone plug must follow the signal order shown
in Figure 4.
VIDEO RECEIVER BRIGHTNESS TEST
The video receiver with the lowest observed video brightness must be installed at the rear panel
RX1 jack. On new installations it is important to determine which FPV receiver has the lowest
brightness, as follows:
1.
With Diversity Demon installed, power up your video system. Point your
video camera at a background scene that offers good contrast and a noise
free image on your monitor / display.
Diversity Demon ©2016-2017 DIGITAL PRODUCTS COMPANY
P
AGE
4
July-31-2017
