Doyon TLOI, Инструкция по эксплуатации

Страница: 7 / 58

A5
INSTALLATION
IN GENERAL
See ¨Warnings¨ and ¨Distance to respect for the installation¨.
Take off the packaging material with care. Take off all the material used for packing and accessories.
Bolt the oven to the floor using the 10 bolts included with the oven. Seal the unit on the floor
with silicone. Install the draft hood on the chimney. Verify every adjustment and correct it if
necessary. Install the hood covering the top front of the oven.
Each unit is set up to be used with the electrical supply specified on the nameplate fixed on the front
of the oven.
1. To the electrician
Electrical supply installation must be in accordance with the electrical rating on the nameplate.
WARNING
The electrician must make sure that the supply cable does not come in contact with the
oven top which becomes hot.
A phase sequence and loss of phase relay is installed on 3 phases models to avoid wrong rotation
direction of the blowers. If the oven does not light up, swing two phases conductors in the
supply box and try again. Be sure that the power is really on the 3 phases wires next to the fuses
in the control compartment on the front of the oven. Check also if the control fuse located near
the main switch is not blown.
2. To the plumber
•
Connect the water supply pipe to the oven using good quality sealing compound. Take care
that combustible water pipes do not come in contact with hot parts on the top of the oven.
•
Check for leaks of solenoid valve.
Note: The water flow valves for steam have been adjusted, DO NOT TOUCH.
This equipment is to be installed to comply with the applicable federal, state, or local plumbing
codes.
Connect the steam system (1/4 NPT) to the cold water distribution network. We highly
recommend a water softener to eliminate minerals in the water. We suggest to use CUNO #
CFS6135 (Doyon part number PLF240).