2510SEC
28
03.27929.000
4.2. Preparing the stove
Please inspect the stove for damage caused during transport immediately after deliv-
ery and notify your distributor in case there are any defects. Do not put the stove
into operation in the meantime.
In order to avoid damaging the stove during installation and to make handling of the
stove easier, it is recommended to remove previously all loose parts (fire-resistant
bricks, grille, ashtray, ...) from the stove. Note the location of those parts while re-
moving them, so that you have no difficulties in re-assembling the parts later on.
4.2.1. Changing the direction of the door-opening
It is possible to change the direction of the door opening. On each side you have
already the system.
4.2.2. Removing the clapet
You can remove the clapet and the tige by holding it upward and moving it a little
over the baffle-plate. When you loose the bolt in the topplate you can remove the
baffle plate.
4.2.3. Assembling the “cold handle”
Assemble the different parts of the handle, i.e. a screw M8x50,
a wooden handle, a hook and a nut, as indicated on the sketch.
