Dovre 2300GL, Руководство по установке

Страница: 7 / 18

2300 - 2400
7
03.27997.000
3.2. Preparation
Please inspect the fireplace for damage caused during transport immediately after
delivery and notify your distributor in case there are any defects. Do not put the ap-
pliance into operation in the meantime.
In order to avoid damaging the fireplace during installation and to make its handling
easier, it is recommended to remove previously all loose parts (fire-resistant bricks,
grille, ashtray, ...) from the stove. Note the location of those parts while removing
them, so that you have no difficulties in re-assembling the parts later on.
The stove will be supplied with the following parts:
•
A set of legs
•
A smoke dome with fixing material
•
A flue collar with fixing material
•
A “cold handle” to open the door
•
An ashtray (option)
3.2.1. Assembly of the legs
Carefully tilt the appliance onto its backside .
Fix the leg holders on the bottom plate with nut M8
and collar Ø8xØ17.
Adjust the height of the leg on the holder with bolt
M8x50, nut M8 and both collars Ø8xØ25.
Fix the adjustment bolts under the legs. These will
allow to adjust the fireplace level.
3.1.4. Combustible material round the fireplace
Within the radiation area of the fireplace
Assure a distance of at least 80 cm between the opening of the fireplace and com-
bustible material. That distance may be reduced to 40 cm if the combustible mate-
rial is sufficiently shielded and well ventilated.
Outside the radiation area of the fireplace
Assure a distance of at least 5 cm between the mantle built
around the fireplace and combustible material. A small sur-
face contact between combustible material and the mantle
(e.g. wall cladding) is allowed if the mantle of the fireplace
is sufficiently insulated.
A wooden ornamental rafter must not be installed within
the radiation area of the fire. Outside the radiation area,
there must always be a ventilation gap of 1 cm all around
to prevent heat from building up (see picture).
No combustible material must be present within 50 cm from the convection outlet
areas.
min 1 cm
min 1 cm