Dover Hillphoenix AGB-RG, Руководство по установке и эксплуатации

Страница: 15 / 26

LIGHTING & POWER SUPPLIES
Fig. 9 Open clamp Fig. 8 Closed clamp
Re-installing LED luminaires:
1. Place a ring (Fig. 10) around each end of the light rod and
rotate until both edges of the rod line-up and snap ahold
to the ridges in the ring.
2.
Slide a clamp (Fig. 10) over each ring and close them
tight around the rings by clipping together the clamp ends
located above the screw opening.
C A U T I O N
Too much tension on the inner clamp rings while
removing them from an LED light rod may cause
breakage. Use only enough tension for removal.
▲
Fig. 10 LED ring and clamp
RING
CLAMP
3.
Line-up the closed clamps (Fig. 8) and light rod with the
existing screw holes on the case and re-attach.
4. Rotate the light rod into desired position after the clamps
are fi rmly re-attached.
11