Lit. No. 74226, Rev. 00
9
September 15, 2020
MOUNTING MANIFOLDS & NOZZLES
1. Position a manifold assembly with
fi
ttings to each
side of the chute frame and align the mounting
holes.
NOTE: The driver-side manifold top port is
plugged. The passenger-side manifold top port
has a 1/2" straight barb
fi
tting.
2. Install the assembly using a 1/4" x 2" cap screw
in the top hole and a 1/4" x 1-1/2" cap screw in
the bottom hole. Secure the cap screws with
1/4" locknuts.
3. Connect the manifolds with a 14" long length of
1/2" tubing between the 90° elbow
fi
ttings. Secure
the tubing with spring-type clamps.
Plug in
Top Port
of Driver-Side
Manifold
Spring-Type
Clamp
1/2" x 14"
Tubing
1/4"
Locknuts
1/4" x 2"
Cap Screw
1/4" x 1-1/2"
Cap Screw
1/2" Straight
Barb Fitting in
Top Port of
Passenger-Side
Manifold
MOUNTING THE TANKS
MOUNTING THE TANKS
NOTE: While handling the hopper, ensure that the
hopper mounting bolts do not damage the liquid
tanks.
If this is a new hopper spreader installation,
follow the installation steps as outlined in the hopper
spreader Installation Instructions. Once the spreader
has been located in the vehicle and the mounting
holes have been made, remove the spreader from
the vehicle. Ensure that the mounting bolts are in the
mounting bar holes before installing the liquid tanks
to the hopper.
If this spreader has been previously installed in
the vehicle,
remove the spreader from the vehicle.
Ensure that the spreader mounting bolts are in the
mounting bar holes before installing the liquid tanks to
the hopper.
Once the tanks have been installed onto the hopper,
place the spreader back into the vehicle and mount
the spreader to the vehicle as described in the hopper
spreader Installation Instructions.
