Lit. No. 74226, Rev. 00
10
September 15, 2020
6. For the J-bolt, place one 2" fender washer and
locknut on the inside of the hopper with the
locknut facing toward the chain. Tighten the nut
toward the hopper body.
NOTE: Do not use power tools to tighten the
J-bolts; use hand tools only. Overtightening can
cause galling of the stainless steel threads.
7. Cut the excess bolt length from the J-bolt if
desired.
8. Repeat Steps 1–7 for the remaining tank.
INSTALLING TANKS & STRAPS
1. Use the stainless steel 3/8" cap screws and
3/8" locknuts to install the tank trays to the sill.
2. Insert a 3/8" x 1" carriage bolt into the tank tray so
that the button head is facing the tank.
3. Place the tank on the tank tray. Verify that the
recess in the bottom of the tank is seated into the
tray.
4. Use the 3/8" x 1" carriage bolt and 3/8" hardware
to install the tank support strap.
5. Loop the 3/8" x 8" J-bolt through the tank support
strap and insert it through the knock-out hole in
the hopper body. Loop the J-bolt so that the hook
is facing upward.
INSTALLING TANKS & STRAPS
3/8"
Cap Screws
3/8" Locknuts
3/8"
Locknut
Tank
Support
Strap
Tank
Tray
J-Bolt
