3
OPERATION
SETTING UP YOUR PRESS
1. Turn the upper and lower platens power switch located on the front
face of the press to the “ON” position. This switch is the master power
On/Off switch for the press.
2. Turn the switch to the “OFF” position when you are done. This will
turn power off to the entire machine.
Up is “ON” and down is “OFF”
THICKNESS CONTROL
1. The thickness control knob, located at the top / rear of
the machine, should be set so that the heat head will
lock down firmly with your product in place.
2. Thickness is reduced by turning knob (with machine
open) clockwise and increased by turning it
counterclockwise.
NOTE:
Adjustments may be required from one product to another and will
vary to achieve the desired result.
CAUTION:
Excessive pressure can cause structural damage, voiding the
machine warranty!
3. To set the finished tortilla thickness, turn the dial on the top of the
machine as indicated.
4. Wait for the machine to reach your preset temperature which will. It
takes approximately 30 minutes for machine to reach full temperature.
5. Swing out the upper platen and place your tortilla dough balls on platen.
You are know ready to produce tortillas.
THINNER
THICKER
