Seat Back Plates - Section 1
/ pg 2
Yamaha Drive: 2-Passenger Factory Supports
Attach the Seat Back Plates to the Seat Back
Supports using 1/4" x 2-1/4" FHP Bolt, Black
Spacer (A), 1/4" Flat Washer (back), and 1/4"
Nyloc Nut (2x both sides – through holes marked
Drive).
NOTE: Fully tighten Bolts.
EZGO RXV: 2-Passenger Factory Supports
Temporarily remove the Bag Holder/
Sweater Basket Assembly from the
Seat Back Supports by removing the
6 Bolts (3 Bolts each side) as shown
below (A).
NOTE: Keep Hardware for reinstall.
EZGO RXV
Yamaha Drive
Attach the Seat Back Plates to the Seat Back
Supports using 1/4" x 1-3/4" FHP Bolt, 1/4" Flat
Washer (back), and 1/4" Nyloc Nut (2x both sides –
through holes marked TXT).
NOTE: Fully tighten Bolts.
EZGO TXT: 2-Passenger Factory Supports
EZGO TXT
(A)
Spacers
Edge of
Seat Back
Plate
Mount
to these
holes
Attach the Universal Seat Back Plates to the Seat Back Supports using 1/4" x
1-3/4" FHP Bolt, 1/4” Flat Washer (back), and 1/4" Nyloc Nut (2x both sides –
through top and bottom holes marked RXV).
NOTE: Fully tighten Hardware.
Install Seat Back Cushion (A) to Seat Plates (see Section 3 for example).
Then, complete your installation by reinstalling the Bag Holder/Sweater
Basket Assembly using the factory hardware (B).
NOTE: Fully tighten allBolts.
(A)
(A)
PROCEED TO SECTION 3
PROCEED TO SECTION 3
INSTALLATION IS COMPLETE
(A)
(B)
(B)
