IMPORTANT: Do not fully tighten hardware until instructed.
Read through all instructions before beginning installation.
MAX 5 SEAT INSTALLATION
TABLE OF CONTENTS:
Section 1
- Prepare Car for Installation
Section 2
- Seat Back Support Installation
Section 3
- Armrest Installation
Section 4
- Footrest Supports and Bumper Angle Installation
Section 5
- Rear Seat Mounting
Section 6
- Cushion Installation
Section 7
- Footrest, Safety Bar and Cup Holders Installation
Sold Separately
Chair Holder
Easy Access Steps
Drop-in Cargo Bed
Golf Bag Holder
Soft Cargo Carrier
Storage Bin
Trailer Hitch
OPTIONAL MAX 5 ACCESSORIES
P R E PA R E C A R F O R I N S TA L L AT I O N
SECTION 1
Remove the following items to prepare the car for Rear Seat Kit Installation:
• Top
• Top Supports/Drain Tubes
• Bench Back Cushion
• Bag Rack Assembly
NOTE: Save and separate factory hardware for later use.
CAR PREPARATION
1:1
CAT-4:
Max5 Rear Seat Kit
/ May 18, 2018
www.DoubleTakeGolfCar.com
MULTI–FUNCTION REAR SEAT
TM
Supplied hardware has been illustrated at a 1:1 scale for the
ability to verify required lengths quickly and easily. Simply place
the hardware on top of the illustration to ensure you are using
the correct item and measurement.
SCALE HARDWARE GUIDE
• If you are installing a Storage Bin and decide to release the Storage Lid from the Seat Base before installing the
Seat Base and Seat Back Cushion onto the Car, do not try to open the Lid past 90°. Doing so may place too much
stress on the Lid Hinge possibly causing failure.
• Once the Seat Base and Seat Back Cushion are installed on the Car, the Seat Back Cushion acts as a stop for the
Lid protecting the Lid Hinge from hyper-extension.
• As a precaution, we recommend installing the Storage Lid Latch only after the Seat is fully installed on the Car.
DO NOT PUSH OR FORCE THE LID PAST 90° BEFORE SEAT BASE & SEAT BACK CUSHION ARE INSTALLED ON THE CAR
