CAT-4:
Max 5 Rear Seat Kit
- 11
O P T I O N A L A C C E S S O RY
( S o l d S e p a r a t e l y )
STORAGE BIN
INSTALL LATCH HANDLE
Remove the two Lid Screws
(FF)
from under the Seat Base.
Squeeze the two small clips
(GG)
together to remove the Hole Cap.
NOTE: Fully tighten Hardware.
Pull the Handle up to draw in the catch
(HH)
. Align the Bottom Latch
Cover and install with provided hardware
(II)
.
NOTE: Fully tighten Hardware.
(FF)
(GG)
(HH)
(II)
(II)
INSTALL BIN
Insert the Bin into the opening, making sure the Notch is facing the Seat Hinge.
OPTIONAL:
Using a 13/32” drill bit, add a Drain Hole in the bottom of the
Storage Bin before installation.
NOTE: The provided drain plug is designed to fit a 13/32” hole.
Make sure the Bin rests inside the Bin Ridge in the Seat Base. Install the
self-tapping Screws thru all holes in Bin into the Seat Base.
Drain Hole
Screw Hole
Screw
Bin Ridge
1
2
SEAT HINGE
SEAT BASE
BIN
TOP VIEW – SEAT HINGE
• If you are installing a Storage Bin and decide to release the Storage Lid from the Seat Base before installing the
Seat Base and Seat Back Cushion onto the Car, do not try to open the Lid past 90°. Doing so may place too much
stress on the Lid Hinge possibly causing failure.
• Once the Seat Base and Seat Back Cushion are installed on the Car, the Seat Back Cushion acts as a stop for the
Lid protecting the Lid Hinge from hyper-extension.
• As a precaution, we recommend installing the Storage Lid Latch only after the Seat is fully installed on the Car.
DO NOT PUSH OR FORCE THE LID PAST 90° BEFORE SEAT BASE & SEAT BACK CUSHION ARE INSTALLED ON THE CAR
NOTCH
OPTIONAL DRAIN HOLE
(13/32” Drill Bit)
