DOTWORKZ COOLDOME S-Type Encolosure series, Инструкция по эксплуатации продукта

Страница: 9 / 21

6
ST-MVP Input Power Configuration for 24 VAC/ VDC
110
– 220 VAC Power Source
Single Phase Only
Step Down Transformer
High Voltage to 24 VAC
The MVP comes ready for 110-220VAC Input power
For 24 VAC/VDC inputs; Installer must take a moment to allow input configuration for Low Voltage Input.
Use Blue 24 VAC Bypass Cable To hook up Power inside S-Type as shown below.
Site Power Available
Inside all ST-MVP is a Chassis similar to shown
Locate Green Plug on Chassis
Then Unplug from panel mount
socket, then push aside
Connections are made fully
inside of ST
Then insert similar Plug
on 24V Bypass Cable
Tighten screws on plug to secure
Locate 24V Bypass Cable in
Hardware Pack Provided
Run 24V into S-Type Enclosure,
24 V D C: Connect wires to appropriate
Color coded terminal shown above.
24 V A C: hook-up has no polarity
24 VDC Color Code:
Red = + Positive
Blue = - Negative
When all wiring is complete, secure screws from plug to panel mount,
secure wiring being sure it does not interfere/ damage fan(s)