DOTWORKZ COOLDOM ST-CD, Руководство по установке

Страница: 16 / 17

S-Type COOLDOME Internal Wiring
S-Type COOLDOME
Before camera &
Power install
S-Type COOLDOME
after power & camera
installation- typical
Pull power and Data cables into housing thru Cable Gland strain relief seal ports near rear of S-Type enclosure. Strip
back wires on Low Voltage 12VDC power cable brought into enclosure, observing DC polarity.
With a Volt Meter, Check voltage on wires pulled in from power supply, before attaching wires to assure Low Voltage
12 VDC input wires and proper polarity.
Hook up +12VDC to red terminal, and (-) DC ground wire to black terminal. Tighten firmly with small flat blade
screwdriver.
Be sure to tighten cable gland seals to assure a weather tight seal.
Gently but firmly tighten four enclosure cover screws to fully seal
enclosure.
Hook up user supplied data cable to camera. Install power cable to camera. (See camera power page if your
camera power cable is not compatible with the power cable shown above)