MAINTENANCE:
RINSE INJECTOR AFTER EACH USE:
additive allowed to remain in injector can dry out and foul or damage lower end at the next
start up.
Put suction tube into a 1 qt. (4 liters) or more container of fresh filtered water. Pull fresh
water through the injector by operating until container is empty. This procedure is not needed for
continuous operation.
BYPASS INJECTOR:
When not in use put the injector in bypass mode by using the three valve
bypass (preferred) or the On/Off lever on the injector. See Fig.4 Pg.8.
CLEAN SUCTION TUBE FILTER SCREEN:
Inspect each time new solution is added. Clean
as frequently as necessary by washing in fresh water. Remove filter screen (#27) from suction tube
(#25) and run water backwards through it. Replace if necessary.
Keep filter screen off bottom of
solution container to prevent dirt and precipitate from contaminating solution.
STORAGE:
For extended storage, rinse injector as described above and place entire injector
underwater (in 5 gal container). Monthly, apply a small amount (thimble full) of chlorine bleach to
avoid algae growth.
CLEAN SOLUTION CONTAINER:
Keep covered to prevent any contaminants from entering
container. Rinse container thoroughly and often. Do not mix chemicals together that might react
and cause a precipitate. Use FILTERED WATER when filling container.
CLEAN INLET FILTER:
Clean or replace inlet filter as required to increase the life of the unit
as well as reduce pressure loss.
REPLACE DOSAGE PISTON AND SHAFT SEAL:
The injector is shipped with a spare Dos-
age Piston (44) and shaft seal (17), see Fig. 1, as these are normal wear parts, replace both when
solution injection is less than set amount.
10
Содержание SuperDos 45
Страница 13: ...NOTES 12 ...
