Splitting Operation
19
b) Set to
Vertical
position
1)
Pull out horizontal lock catch pin, then grasp lifting handle and lift beam until it
rotates into vertical position.
WARNING
:
Crush hazard. The beam is heavy – do not let it just drop. It could
crush fingers or cause damage to the splitter.
2)
Lock in vertical position by rotating vertical lock.
To return to horizontal position, unlock vertical position, grasp lifting handle and lower
beam carefully in a controlled manner until it rests on the tow bar, lock beam in the
horizontal position with catch pin.
4. Start engine
Start the engine.
See the engine owner’s manual for engine starting instructions.
Note:
a) Make sure the hydraulic oil is above 10
o
F before starting the engine. Cold hydraulic
oil can damage the hydraulic pump.
b) If outdoor air temperature is below 32
o
F, allow log splitter to warm up by extending
and returning the wedge several times before splitting wood.
WARNING:
Burns.
To avoid burns, stay clear of hot muffler if you are starting a warm engine.
Carbon monoxide
. The running engine gives off carbon monoxide, a poisonous gas
that can kill you. You CANNOT smell it, see it, or taste it. If you start to feel sick,
dizzy, or weak while using the log splitter, shut off the engine and get to fresh air
RIGHT AWAY. See a doctor. You may have carbon monoxide poisoning.
Other exhaust dangers
.
Engine exhaust, some of its constituents, and certain vehicle
components contain or emit chemicals known to the State of California to cause cancer,
birth defects, or other reproductive harm. Avoid inhalation of exhaust
.
Vertical Splitting Position
Lifting Handle
Horizontal Lock
Lock Catch Pin
Vertical Lock
Содержание M2965020D
