©
DOSATRON INTERNATIONAL /
9
1 - GENERAL REMARKS (cont...)
- Before applying any aggressive
chemicals, please consult
your distributor to confirm
compatibility with the dosing
pump.
- All assembly should be done
without tools, hand tighten only.
2 - WATER WITH HIGH PARTICLE
CONTENT
- A (ex.: 50 mesh - 300 microns
depending on your water quality)
water filter must be installed
upstream from the Dosatron (see
accessories), if a filter is not installed
abrasive substances will cause the
Dosatron to deteriorate prematurely.
3 - WATER-HAMMER /
EXCESSIVE FLOW
- For installations subject to water
hammer a protection device such
as a check valve or union ball check
must be fitted (pressure/flow control
system).
- For automatic installations, slow
opening and closing solenoid valves
are preferable.
- In an installation where a
Dosatron serves several sectors,
the closing of one sector and the
opening of another sector must be
done at the same time (simultaneous
operation of the solenoid valves).
4 - INSTALLATION LOCATION
- The location of the Dosatron and
concentrate container should be
accessible, but should never present
a risk of pollution or contamination.
- It is recommended to label all
water lines with a warning about the
injected solution i.e. Not For Human
Consumption.
5 - MAINTENANCE
- Rinse the injection areas after
using the Dosatron. To do this,
insert suction tube into a container
of clean water and inject about 1 liter
[0.264 US Gallons].
- Routine maintenance once a year
will add to the life of your Dosatron.
Replace the dosing seals as well as
the suction tube annually to ensure
proper injection.
6 - SERVICE
- This Dosatron was tested prior to
packaging.
- Complete maintenance and seal
kits are available.
- Call your DOSATRON® distributor
for service or parts.
PRECAUTIONS (cont...)