English
Ringer
1.
Lift the receiver (ignore the dialling tone) and press the store button
P
and
#
.
2.
Select ring signal by pressing the number keys
0
-
9
in accordance with the table
below.
3.
Press store button
P
and replace the receiver. The ring signal is now set.
Melody type
Key/level
Melody A .........................1=Low, 2=Normal, 3=High
Melody B .........................4=Low, 5=Normal, 6=High
Melody C .........................7=Low, 8=Normal, 9=High
Off* ..................................0
* If the key 0 is selected, the ring signal will be turned off until the next time the receiver is lifted. After
that, the ring signal will revert to the previous setting.
Technical information
Some selector switches are located in a compartment on the underside of the telephone.
These switches control technical parameters for connection to PBX equipment.
IMPORTANT NOTE: These switches should only be adjusted by qualified personnel.
Recall time
Selection of 100/300/600ms timed loop break for recall functionality.
The standard setting is 100 ms for UK/Australia and 600 ms for New Zealand.
EARTH/TIME (UK only)
Selection of either earth or timed loop break recall method.
Tone/Pulse
Selection of either dialling method depending on PBX.
Message Waiting Indicator
Some PBX systems have a function called Message Waiting.
The switch is located behind the battery cover on the underside of the telephone.
The MW function operates differently depending on the PBX in question. Please
contact the system controller for more information. The following four alternatives are
available: +, -, ringer indicator ( ) and high DC voltage (HV). When the telephone is
used in systems without a telephone exchange ( ) should be selected.