Doro 1000 AHS, Руководство пользователя

Страница: 2 / 4

Doro 1000 AHS
Connection
Handset batteries must be fully charged before registration to the main base unit.
1.
Connect the charger’s mains adapter* to an electrical wall socket.
2. Remove the battery cover from the back of the handset. Insert
the batteries into the handset ensuring correct battery polarity is
observed. Replace the battery cover.
3. Charge the handset batteries without interruption for 24 hours
initially (thereafter fully discharged batteries will take 10 hours to
recharge).
*Use adapter Model S090050D31 only for the base unit and S060015D22 for the
extra charger (+1 only).
Wall mounting
The charger can be wall mounted using two horizontally mounted
screws, 49mm apart. The screw heads should then fi t into the two
“keyholes” on the back of the charger unit.
Registration
This handset must be registered to the main base unit.
1.
Hold down the paging button
j
on the base unit for a few seconds
until the indicator
Q
/
7
starts fl ashing. Registration mode will
remain active for one minute.
2. Scroll to BASE SUB. Press
p/
OK
.
3.
Select the number for the desired base unit by pressing the
corresponding keypad button
1
-
4
.
4.
The display shows SEARCHING.
4.
The base unit RFPI code is shown. Press
p/
OK
.
5.
Enter PIN number (0000 when supplied). Press
p/
OK
.
6.
If the registration is successful the handset will return to standby
mode in a few seconds.