Dorner AquaPruf 7400 Ultimate CE Series, Инструкция по установке, эксплуатации и запасным частям

Страница: 16 / 46

Dorner Mfg. Corp. 16 851-638 Rev. E
7400 Series CE End Drive Conveyors
Installation
9. If no more travel is available, remove one or more belt
links to take up the tension. Refer to “Standard Belts:
Replacing a Section of Belt” on page 19.
Belt Return Installation
Typical Belt Return Components (Figure 42)
Figure 42
1. Attach the chain return shoes (Figure 43, item 1) to the
return shaft (Figure 43, item 2) .
Figure 43
2. Slide the return shaft (Figure 44, item 1) up and
through the large slot (Figure 44, item 2) in the frame
(picture shown without the belt or wear strips).
Figure 44
3. Push up on the return shaft (Figure 44, item 1) and
slide the notched end of the shaft through the small slot
on the opposite side of the frame.
4. Check belt sag by measuring from the top of the return
(Figure 45) . Belt sag should not exceed 102 mm.
Follow steps 7 – 9 in the “Belt Installation” section on
page 15 to remove slack from the belt.
Figure 45
1 Return shaft
2 Chain return shoe
1
2
1
2
1
2
CAUTION
CAUTION
Belt sag should not exceed 102 mm from the
top of the returns.
1
2
Up to 102 mm