Dorner 1100 Series, Инструкция по установке, эксплуатации и ремонту, Страница: 7 / 32

851-747 Rev. B 7 Dorner Mfg. Corp.
1100 Series Mid Drive Conveyors
Installation
Figure 3
Figure 3
Installation Component List
Required Tools
• Hex-key wrenches:
2 mm, 2.5 mm, 3 mm, 4 mm
• Level
• Needle Nose Pliers
• Torque wrench
Recommended Installation
Sequence
• Attach mounting brackets to conveyor
• Attach conveyor to stands
• Install return rollers on conveyor
• Attach guides/accessories (see page 32 through page 52 of
“Service Parts” section for details)
Mounting Brackets
Standard Mounting Bracket
1. Locate short or tall mounting brackets. Exploded views
shown in Figure 4 & Figure 5.
Figure 4
Figure 4
Figure 5
Figure 5
2. Remove screws (Figure 4, item 1) or (Figure
5, item 1) , and T-bars (Figure 4, item 2) or (Figure
5, item 2) from short brackets (Figure 4, item 3) or tall
brackets (Figure 5, item 3) .
NOTE
Conveyor comes assembled with mount
package and gearmotor attached. If
maintenance is needed to the components
see 1100 Series Mid Drive Mounting Package
manual 851-749.
NOTE
Conveyor MUST be mounted straight, flat and
level within confines of conveyor. Use a level
(Figure 3, item 1) for setup.
Conveyor frame (two sections if longer than 12ft)
Conveyor brackets (4x)
Return rollers (for longer conveyors)
1
1
2
1
3
1
1
2
3