Dorner 1100 Series, Инструкция по установке, эксплуатации и ремонту, Страница: 19 / 32

851-747 Rev. B 19 Dorner Mfg. Corp.
1100 Series Mid Drive Conveyors
Preventive Maintenance and Adjustment
4. Install two screws (Figure 41, item 1) onto each side of
pinch plate (Figure 41, item 2) to secure assembly onto
conveyor. Leave loose until mid drive module is
assembled and aligned properly.
Figure 41
Figure 41
5. Install drive gear (Figure 42, item 1) onto shaft.
Figure 42
Figure 42
6. Install belt (Figure 42, item 2) . See “Conveyor Belt
Replacement” on page 11.
Idler Spindle Installation
1. Install tail plate assembly with notch (Figure
43, item 1) in tail plate matching with slotted portion
(Figure 43, item 2) of shaft.
Figure 43
Figure 43
2. Assemble the idler spindle bearings (Figure 44, item 1)
onto shaft onto each tail plate as shown and raise idler
spindle assembly T-bars
(Figure 44, item 2) to the
conveyor frame.
Figure 44
Figure 44
3. Tighten screws 12 in-lb (1.4 Nm). (Install belt and see
“Conveyor Belt Tensioning” on page 14 to tension belt
to specification.)
1
2
2
1
1
2
2
2
1